Skip to main content
Menu
0 items

Haynes On Demand sales are currently limited to residents of the United Kingdom only.

Checking tyre condition Ford Fiesta 2008 - 2011 Diesel 1.4 TDCi

OnDemand step-by-step maintenance & repair BETA

Ford Fiesta 2008 - 2011  | 1.4 TDCi Checking tyre condition

  • time 10 minutes
  • difficulty 1
The original tyres have tread wear safety bands (B), which will appear when the tread depth reaches approximately 1.6 mm. The band positions are indicated by a triangular mark on the tyre sidewall (A)
Alternatively, tread wear can be monitored with an inexpensive device known as a tread depth indicator gauge
Tyre shoulder wear is caused by under-inflation, incorrect wheel camber (worn suspension parts) or hard cornering
Tyre centre wear is caused by over-inflation
Uneven tyre wear is caused by unbalanced wheels, worn/broken suspension parts, or incorrect wheel alignmentIf you need to change a wheel, click below
- Close + Open

Roadside wheel change

Lift the floor covering and unscrew the spare wheel clamp bolt.
Lift out the spare wheel . . .
. . then take out the jack and tools located in the spare wheel well.
Use the special tool or screwdriver provided to pull the wheel trim from the wheel or wheel nuts, then slacken each wheel nut by half a turn.
Locate the jack head below the jacking point nearest the wheel to be changed; the jacking point is indicated by a reinforced section in the sill. Ensure that the slot in the jack head engages with the sill flange at the jacking point. Raise the vehicle until the wheel is clear of the ground, then remove the wheel.
Fit the spare wheel and tighten the nuts moderately with the wheelbrace.
Lower the vehicle to the ground, then finally tighten the wheel nuts in a diagonal sequence. Refit the wheel trim. Note that the wheel nuts should be tightened to 110 Nm (81 Ibf ft) at the earliest opportunity.
All OnDemand jobs for your car
£9.99
1 year subscription

Already purchased this job? Log into your account to view