Skip to main content
Menu
0 items

Haynes On Demand sales are currently limited to residents of the United Kingdom only.

Brakes, suspension & tyres Honda Accord 2003 - 2008 Petrol 2.0 VTEC

OnDemand step-by-step maintenance & repair BETA

Honda Accord 2003 - 2008  | 2.0 VTEC Brakes, suspension & tyres

  • time 20 minutes
  • difficulty 3
With the wheel off the ground, check for wear in the wheel hub bearings by grasping the wheel and trying to rock it. A very slight play may be felt. That is OK, but if the movement is appreciable, you should seek further advice
Now remove the wheel...
Check condition of the brake discs. Some light scoring is normal on the area in contact with the brake pads, but if heavy scoring and/or cracks are found on the disc or around the wheel bolt holes, the disc must be renewed. ALWAYS replace both front discs and pads
Now locate the brake pads, there are two, one on each side of the disc. Locate the brake pads' wearing surface. It's the wear material that is pressed against the brake disc to slow the vehicle when the brake pedal is applied
Using a ruler, measure the approximate thickness of the remaining wear material on the brake pad. If it is less than 1.5mm all front pads need replacement
TIP! Virtually all cars have this inspection window in the brake calliper body. You can usually see the brake pad thickness from here
Now quickly check all the brake pipes for condition, check for any leaks, also inspect the rubber gaitors for integrity. Seek advice should you detect a problem. Replace the wheel and repeat on the other side
It is a similar procedure with the rear wheels. Check for wheel bearing movement, then remove the wheel
Check condition of the rear brake discs
Locate rear brake pads...
Measure brake pad wear thickness. If it is less than 1.5mm all rear pads need replacement
Take a good look around brake system and the suspension arm, and check for any leaks. Seek advice should you any detect leakage and/or serious damage to the components
Check rubber exhaust mountings
Before refitting the tyres, take a look at the tyre tread. There is a UK legal requirement to have a minimum of 1.6mm remaining tread depth. Also check sidewalls for any kerb damage
Finally, check the condition of the spare wheel / emergency tyre repair system
Start with the front wheels