Skip to main content

Haynes On Demand sales are currently limited to residents of the United Kingdom only.

Roadside wheel change Mercedes-Benz C-Class 2000 - 2007 Petrol C180 - 2.0

OnDemand step-by-step maintenance & repair BETA

Mercedes-Benz C-Class 2000 - 2007  | C180 - 2.0 Roadside wheel change

  • time 10 to 30 minutes
  • difficulty 1
Note: Some models have a collapsed tyre to save space. There is an electric air pump stored with the wheel changing tools to inflate the spare tyre when required. Other models have the TYREFIT system which uses sealant on the punctured tyre.
Warning: Do not change a wheel in a situation where you risk being hit by other traffic. On busy roads, try to stop in a lay-by or a gateway. Be wary of passing traffic while changing the wheel – it is easy to become distracted by the job in hand.
The spare wheel is stored in the luggage compartment. Raise the floor covering, and lift out the spare wheel and wheel changing tools.
On Estate models, the wheel changing tools and jack are stored behind the left-hand rear inner panel.
Use the wheelbrace to slacken each wheel bolt by half a turn.
Unscrew the plastic retainer and remove the spare wheel.
Locate the jack on firm ground below the reinforced point on the sill (don’t jack the vehicle at any other point of the sill), then turn the jack handle clockwise until the wheel is raised clear of the ground.
Unscrew the wheel bolts and remove the wheel.
Fit the spare wheel, and screw in the bolts. When fitting a steel spare wheel, shorter bolts will be provided with the spare wheel. Lightly tighten the bolts with the wheelbrace then lower the vehicle to the ground.
Securely tighten the wheel bolts in a diagonal sequence and then (where applicable), refit the wheel trim. Note that the wheel bolts should be tightened to 110 Nm (81 Ibf ft) at the earliest possible opportunity.
Note: If a temporary ‘space-saver’ spare wheel has been fitted, special conditions apply to its use. This type of spare wheel is only intended for use in an emergency, and should not remain fitted any longer than it takes to get the punctured wheel repaired. While the temporary wheel is in use, ensure it is inflated to the correct pressure, do not exceed 50 mph, and avoid harsh acceleration, braking or cornering.
All OnDemand jobs for your car
1 year subscription

Already purchased this job? Log into your account to view