Skip to main content

Haynes On Demand sales are currently limited to residents of the United Kingdom only.

Brakes, suspension & tyres Rover 75 1999 - 2005 Petrol 2.0

OnDemand step-by-step maintenance & repair BETA

Rover 75 1999 - 2005  | 2.0 Brakes, suspension & tyres

  • time 20 minutes
  • difficulty 3
Start with the front wheels
With the wheel off the ground, check for wear in the wheel hub bearings by grasping the wheel and trying to rock it. Very slight play is OK, but if the movement is appreciable, you should seek further advice
Now remove the wheel
Check condition of brake discs. Some light scoring is normal on the area in contact with the brake pads, but if heavy scoring and/or cracks found on the disc or around the wheel bolt holes, the disc must be renewed. ALWAYS replace both front discs and pads
Now locate the brake pads, there are two, one on each side of the disc. Locate the brake pad wearing surface
Using a ruler, measure the approximate thickness of the remaining wear material on the brake pad. If it is less than 2.0mm, all front pads need to be replacedIf you need to replace the front pads, click below
TIP - Virtually all cars have this inspection window in the brake caliper body, you can usually see the brake pad thickness from here
Now quickly check all the brake pipes for condition, check for any leaks, also inspect the rubber gaitors for integrity. Replace the wheel and repeat on the other sideShould the front suspension strut need to be replaced, click below
As with the fronts, check for wear in the rear wheel hub bearings by grasping the wheel and trying to rock it. Very slight play is OK, but if the movement is appreciable, you should seek further advice
Check condition of the rear brake discs
Locate rear brake pads
Measure brake pad wear thickness. If it is less than 2.0mm, all rear pads need to be replacedIf you need to replace the rear pads, click below
Take a good look around brake system and the suspension arm, check for any leaks. Should the rear shock absorber need to be replaced, click below
Check rubber exhaust mountings
Before refitting the wheels, take a look at the tyre tread, there is a UK legal requirement to have a minimum of 1.6mm remaining tread depth. Also check sidewalls for any kerb damage
Finally, check the condition of the spare wheel / emergency tyre repair system
All OnDemand jobs for your car
£5.99
1 year subscription

Already purchased this job? Log into your account to view