Dealing with a Chrysler Sebring that won’t start and just clicks can be frustrating and worrisome, especially when you’re in a hurry. This problem is fairly common and often traced back to a few key components in your vehicle. Identifying the potential reasons and fixes for this issue can help you get back on the road quickly and confidently.
Common Reasons Your Chrysler Sebring Won't Start and Just Clicks
- Dead or Weak Battery: A dead or weak battery is the most common cause when your Chrysler Sebring won’t start and just clicks. The clicking sound you hear is typically the starter solenoid trying to engage but not having enough power to turn over the engine. Signs of a weak battery include dim lights, slow cranking, and a clicking noise when you turn the key.
- Corroded or Loose Battery Connections: Corroded or loose battery terminals can prevent the electrical current from reaching the starter motor, leading to a clicking noise and no start. This issue is often accompanied by visible corrosion around the battery terminals or a loose connection that can easily be moved by hand.
- Faulty Starter Motor: If the battery is in good condition but your Chrysler Sebring won’t start just clicks, the problem could be a faulty starter motor. The starter motor is responsible for turning the engine over, and if it’s worn out or malfunctioning, it might only produce a clicking noise without starting the car.
- Bad Alternator: The alternator charges the battery while the car is running. If it fails, the battery may not have enough power to start the car. Signs of a failing alternator include dimming headlights, electrical issues, and a dead battery.
- Defective Starter Relay: The starter relay sends power to the starter motor. If it’s defective, it can result in the clicking noise you hear when trying to start your car. The relay might be stuck or broken, preventing the necessary current from reaching the starter motor.
Steps to Fix the Clicking Noise and Starting Issue
- Check the Battery: Start by checking the battery for charge. Use a multimeter to measure the voltage; a fully charged battery should read around 12.6 volts or higher. If the voltage is low, try jump-starting the car or replacing the battery if it's old or damaged.
- Clean and Tighten Battery Connections: Inspect the battery terminals for corrosion and ensure the connections are tight. Clean any corrosion with a mixture of baking soda and water, and use a wire brush to clean the terminals. Ensure the clamps are tightly secured to the battery posts.
- Test the Starter Motor: If the battery is good and the connections are clean, the next step is to test the starter motor. You can use a test light or multimeter to check for power at the starter motor when the key is turned. If there’s power but the motor doesn’t crank, the starter may need to be replaced.
- Inspect the Alternator: Check the alternator by starting the car (if possible) and measuring the voltage at the battery terminals with a multimeter. It should read between 13.8 and 14.2 volts with the engine running. If it’s significantly lower, the alternator may not be charging the battery properly.
- Replace the Starter Relay: Locate the starter relay in your vehicle’s fuse box and test it for continuity. If it’s faulty, replace it with a new relay. This is an inexpensive and straightforward fix that can often resolve the clicking noise.
When your Chrysler Sebring won’t start just clicks, it can be a worrying situation, but by understanding the potential causes and taking the right steps, you can often resolve the issue yourself. We provide detailed repair manuals that guide you through these processes with ease, helping you maintain and repair your vehicle confidently. Visit our collection of manuals for step-by-step instructions and expert advice on keeping your Chrysler Sebring in top condition.